Access electronic-circuit test points with a high-input-impedance active probe. Rent the HP 41800A or request measurement services for signal-circuit and RF development, troubleshooting, and maintenance in Monterrey, Mexico.
About the HP 41800A
The 41800A active probe works with compatible network and spectrum analyzers. It helps access circuit nodes while reducing measurement loading compared with a direct low-impedance connection, within the operating conditions specified by the manufacturer.
Reference characteristics
- Frequency coverage: 5 Hz to 500 MHz.
- Typical probe-only input: 100 kΩ and 3 pF.
- 10:1 and 100:1 dividers for selected measurement configurations.
- Power from a compatible instrument or the external supply specified by the manufacturer.
These are documented model characteristics. System performance depends on the analyzer, adapters, divider, and test conditions. The quotation confirms which accessories are included.
Probe and accessory rental
Rent the probe for your existing bench or request a configuration with a compatible analyzer and power source. We define the required tip, divider, output connection, and power arrangement before delivery. Availability, rental dates, and unit documentation are confirmed in the proposal.
Electronic and RF measurement services
- Signal exploration at accessible circuit-board nodes.
- Spectral analysis and frequency-component evaluation with a compatible analyzer.
- Frequency-response measurements using an appropriate test system.
- Comparison of prototypes, reference units, and devices under investigation.
- Trace recording and a technical report with an agreed scope.
Preparing your measurement
Provide the frequency range, signal amplitude, DC bias, and circuit-grounding arrangement. These details help select the divider and verify the input limits and setup compatibility. Operate the probe within its documented limits.
Request rental or services
Tell us whether you need the probe alone or a measurement service, your analyzer model, sample quantity, dates, and required results format. We will define the equipment configuration and project scope with you.